Sonnet-technologies Fusion R400S RAID (Without Drives) Uživatelský manuál

1U Rackmount 4-Drive Hardware RAID 5 SATA Storage System with eSATA InterfaceFUSION™ R400S RAIDUser’s GuideForWindows

8Status LED IndicationsSystem Powered, No Data Reads or WritesWhen the Fusion R400S RAID is powered on, and no data is being written or read, the Powe

Tips and Additional Information• Follow the instructions in this manual carefully; contact your reseller or local distributor for additional advice n

©2012 Sonnet Technologies, Inc. All rights reserved. Sonnet, the Sonnet logotype, Simply Fast, the Simply Fast logotype, Creativity Stored Here, and F

Fusion R400S RAID Features1➊ ➋ ➍➌➎➏ ➐ ➑ ➒ ➓➎ ➎ ➎ 1 – Power Indicator LED This blue LED lights when the Fusion R400S RAID is powered 2 – Rebuild In

Figure 1Figure 3Figure 4 1. Remove the Fusion R400S RAID from its packaging, and place it on a flat, level surface. 2. If you intend to use the Fusio

3Drive Mode DescriptionsThe following two pages describe the various drive modes supported by the R400S RAID. To configure the Fusion R400S RAID’s driv

4Drive Mode DescriptionsRAID 5: Striping, Parity Distributed Among DrivesRAID 5 increases reliability while using fewer drives than mirroring by using

Figure 11Power Rebuild1 2 3 4Figure 125Drive Mode Selection InstructionsGeneral InformationDrives installed into the Fusion R400S RAID must be configur

OS X Users’ Instructions 1. After setting the disk mode and turning on or restarting your computer, a Disk Insertion window will appear stating that

11. When the Format Partition window appears, enter a new name for the volume table if you’d like. Select Perform a quick format, and then click Next